•
Insert the second key in the
ignition switch and turn to position
II.
•
Remove the key from the ignition
switch.
•
Insert the first key in the ignition
switch, turn to position II and hold.
The control light flashes for five
seconds.
•
If the ignition is switched off during
these five seconds, the erasure
process is terminated and no key
is erased.
•
If the erasure process is
completed, all the other keys,
apart from the two used for
erasure, can no longer be used
unless recoded.
Additional keys can now be coded.
ARMING THE ENGINE
IMMOBILISER
The engine immobiliser is armed
automatically a short time after you
have switched the ignition off.
The indicator in the instrument cluster
will flash to confirm that the system
is operating.
DISARMING THE ENGINE
IMMOBILISER
The engine immobiliser is disarmed
automatically when you switch the
ignition on with a correctly coded key.
The indicator in the instrument cluster
will come on for approximately three
seconds and then go out. If the
indicator stays on for one minute or
flashes for approximately one minute
and then repeatedly at irregular
intervals, your key has not been
recognised. Remove the key and try
again.
If you attempt to start the engine with
an incorrectly coded key, you will
need to wait for approximately 20
seconds before attempting to start
the engine again with a correctly
coded key.
If you are unable to start the engine
with a correctly coded key, this
indicates a malfunction. Have the
immobiliser checked immediately.
31
Engine immobiliser
To Next Page
Loading...
