Ford TOURNEO CONNECT - Headlights

if necessary and have the vehicle battery
checked b
y a correspondingly qualified
workshop.
Coming Home and Leaving Home
func
tion (orientation lighting)
The Coming Home and Leaving Home
function lights up the area immediately
surrounding the vehicle when you get in or
out of the vehicle in darkness.
The Coming Home and Leaving Home
function is controlled automatically by
a light sensor.
The switch-o delay can be set and the
function activated or deactivated in the ve-
hicle settings in the Infotainment system
→ page 34.
Activating the Coming Home function
1. Switch o the ignition.
The Coming Home lights are switched
on when automatic lighting control
is switched on and the light sensor de-
tec
ts darkness.
The switch-o delay starts when the
last vehicle door or the boot lid is
closed.
Deactivating the Coming Home func-
tion
1. Automatically aer the set switch-o
delay has elapsed.
Or: automatically if a vehicle door or
the boot lid is still open approximately
30 seconds aer switch-on.
Or: press the light switch as oen as
necessary until the setting
is dis-
pla
yed in the instrument cluster.
Or: switch on the ignition.
Activating the Leaving Home function
1. Unlock the vehicle when automatic
lighting control
is switched on and
the light sensor detec
ts darkness.
Deactivating the Leaving Home func-
tion
1.
Automatically aer the switch-o de-
lay.
Or: lock the vehicle.
Or: press the light switch as oen as
necessary until the setting
is dis-
pla
yed in the instrument cluster.
Or: switch on the ignition.
Headlights
Headlight range control
Hea
dlight range control can be used to ad-
just the low beam light cone to the vehicle
load level. This gives the driver the best vis-
ibility possible and means that oncoming
trac will not be dazzled →
.
T
he headlight range can be adjusted in the
Infotainment system, depending on the
equipment.
Manual headlight range control
Adjusting in the Infotainment system:
1. Press the
button or function but-
ton.
2.
Tap the
Vehicle
and function buttons
to open the V
ehicle settings menu.
3. Tap the
Headlights
function button to
open the Light s
ettings menu.
4. Tap the
Headlight
range control
function
button.
5.
Tap the required setting value (typical
vehicle load level).
Settings in the
Infotainment
system
Front seats occupied and
lugga
ge compartment
empty.
All seats occupied and
lugga
ge compartment
empty.
112 Lights