POWER STEERING FLUID
CHECK
WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
plenty of water and contact your doctor.
CAUTION
Make sure that the level is between
the MIN and the MAX marks.
If the level is at the MIN mark, top up
immediately.
Topping up
Remove the filler cap.
CAUTION
Do not top up further than the MAX
mark.
Top up with fluid that meets the Ford
specification. See Technical
specifications (page 112).
WASHER FLUID CHECK
Note:
The front and rear washer systems
are supplied from the same reservoir.
When topping up, use a mixture of
washer fluid and water to help prevent
freezing in cold weather and improve the
cleaning capability. We recommend that
you use only high quality washer fluid.
For information on fluid dilution, refer to
the product instructions.
TECHNICAL SPECIFICATIONS
Vehicle fluids
SpecificationRecommended fluidPart
WSS-M2C913-C
Castrol Engine Oil
*
Engine oil
WSA-M2C-195-A
Ford or Motorcraft Power
Steering Fluid
Power assisted steering
WSS-M97B44-D
Motorcraft SuperPlus Anti-
freeze
Coolant
WSS-M6C57-A2
Ford or Motorcraft Super
DOT 4 Brake Fluid
Brake fluid
*
Providing it meets the specification defined by WSS-M2C913-C, you can also use
Ford Engine Oil or an alternative engine oil.
Topping up the oil: If you are unable to find an oil that meets the specification defined
by WSS-M2C913-C, you must use SAE 5W-30 (preferred), SAE 5W-40 or SAE
10W-40 that meets the specification defined by either ACEA A5/B5 (preferred) or
ACEA A3/B3. Using these oils can result in longer engine cranking periods, reduced
engine performance, reduced fuel economy and increased emission levels.
Castrol engine oil recommended.
112
Maintenance
To Next Page
Loading...
