Incoming calls can be accepted by
pressing the MODE button once. Press
the button again to end the call.
USING THE TELEPHONE -
VEHICLES WITHOUT:
NAVIGATION SYSTEM
This chapter describes the phone
functions of the audio unit.
Note:
Refer to your audio guide for
details of the controls.
An active phone must be present.
Even if connected to the audio unit, your
phone can still be used in the usual way.
Note:
You can exit the phone menu by
pressing any source button CD, AM/FM
or AUX.
Making a call
Dialling a number using voice
control
Phone numbers can be dialled using voice
control. See Telephone commands
(page 146).
Dialling a number using the address
book
You can access your phone address
book via Bluetooth. The entries will appear
in the unit display.
1.
Press the PHONE or the call accept
button.
2.
Press the MENU button.
3.
Keep pressing the MENU button until
PHONEBOOK appears.
4. Press the seek buttons to select the
desired phone number.
Note:
Press and hold the seek button to
skip to the next letter in the alphabet.
5.
Press the PHONE or the call accept
button to dial the selected phone
number.
Ending a call
Calls can be ended by pressing the call
reject button.
Audio units without a telephone keypad
can also end a call by pressing either
PHONE, CD, AM/FM or ON/OFF, or
by pressing the MODE button on the
remote control
Redialling a number
1.
Press the PHONE or the call accept
button.
2.
Press the MENU button.
135
Telephone
To Next Page
Loading...
