Main Control — Pump
Removal
1. Place the transaxle range selector lever in the PARK position.
2. Remove the engine air cleaner assembly. For additional information, refer to Section 303-12.
3. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.
Disconnect the battery. For additional information, refer to Section 414-01.
4. Disconnect the electrical connectors.
1. Disconnect the digital transmission range (TR) sensor electrical connector.
2. Disconnect the transaxle electrical connector.
3. Disconnect the wire harness from the bracket.
5. Remove the wiper arm and pivot assembly. For additional information, refer to Section 501-16.
SECTION 307-01: Automatic Transaxle/Transmission 2001 Windstar Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 06/13/2000
Special Tool(s)
Aligner, Valve Body
307-167 (T86P-70100-C)
Support Bar, Engine
303-290A or equivalent
Adapter for 303-290A (Support Leg)
303-290A-03A
Lifting Bracket Set, Engine
303-D095 (D94L-6001-A) or equivalent
Adapter for 303-290A (Spreader Bar)
303-290A-10
Adapter for 303-290A (Support Bracket)
303-290A-11
Adapter for 303-290A (Strut)
303-290A-09
2001 Windstar Workshop Manual
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS1W/~MUS~LEN/19/
To Next Page
Need help?
General
