Ford ZD Escape Series - Page 42

-42-
License plate lamps
Slide the unit as shown in the gure 1.
above to remove it.
Turn the socket and bulb assembly 2.
counterclockwise and remove it.
Disconnect the bulb from the 3.
socket.
Interior lamps
Wrap a small athead screwdriver 1.
with a soft cloth to prevent damage
to the lens and remove the lens by
carefully prying on the edge of the
lens with the screwdriver.
Disconnect the bulb by pulling it out.2.
Map lamps
Lighting
Rear direction indicators
Remove the screws with a Phillips 1.
screwdriver and remove the rear
combination component.
Turn the socket and bulb assembly 2.
counterclockwise and remove it.
Disconnect the bulb from the 3.
socket.
Reverse lamps
Due to the complexity and difculty of the
procedure, it is strongly recommended
to have the bulbs replaced by an
Authorised Ford Dealer.
High-mount brake lamp
Due to the complexity and difculty of the
procedure, it is strongly recommended
to have the bulbs replaced by an
Authorised Ford Dealer.