FORGE ADOUR Origin Series - Control Switch Positions and Malfunctions

EN
Stop
High ame
Low ame - Lighting
Direction for use
Positions of the control switch
Point to be checked in case of malfunction :
No inow of gas :
1. Check that the gas supply is
open (bottle)
2. Check th contents of the gas
bottle.
3. Check that the pressure relief
valve has been properly primed (refer to
the instructions provided by the relief valve
manufacturer).
The burner does nit light up :
1. Piezzo starter failure or cable
disconnected.
2. Dirty burner or cloggerd
injector.
3. Absence of gas or insicient
pressure.
The burner keeps going out :
1. Thermocouple failure or
improperly positioned.
2. Unsuitable weather conditions.
No spark on lighting :
1. Check the polarity of the
battery and the positioning of the spring.
Replace the battery.
https://www.kipogeorgiki.gr
https://www.kipogeorgiki.gr