Format Light - Page 5

11
BEDIENUNGS- UND MONTAGEANLEITUNG
FORMAT Fire Safe Light
EN
Changing batteries
The four AA batteries are located in the battery
compartment on the inside of the door.
Open the door and remove the cover of the battery
compartment (Figure 3).
When inserting the new batteries, make sure the
polarity is correct in the battery compartment.
After inserting the batteries, replace the cover. Then,
with the door open, check that the lock is working pro-
perly.
4 ANCHORING
Asstandard,thedocumentprotectionsafeisprovidedwithananchoringholeintheoor
and in the rear wall. Both anchoring holes are closed with a plastic plug as standard. Before
anchoring, the plugs must be removed from the holes.
If the supplied anchoring material cannot be used due to the nature of the substrate, the
anchoring material must be adapted to the condition of the substrate.
The cabinet achieves its optimal protective function only once it has been attached to a so-
lid part of a building. Please use only the provided anchorage holes to make the necessary
xedconnection.
Important! Before anchoring, make absolutely sure that the substrate is suitable
for the xing material supplied and that there are no cables, lines, pipes or similar
in the drilling area.
4.1 Anchoring method
Place the cabinet at the intended location and align it so it is level. The cabinet door must
remain in position and must not move automatically.
Mark the drilling position in the area to be anchored through the anchoring hole in the
cabinet. Remove the cabinet again and drill the anchoring hole in the substrate with a drill
bit suitable for the anchoring material. Now clean the drillhole (suck out drilling dust) and
insert the plug into the drill hole.
Putthedocumentprotectionsafebackinitsnalpositionandscrewitdownuntilthescrew
head is tight against the fastening sleeve inside the cabinet.
5 MAINTENANCE AND SERVICE
The bolt mechanism and the lock are maintenance-free.
If you have any further questions about your document protection safe or if technical pro-
blems occur, please contact your dealer or the manufacturer of your document protection
safe:
FORMAT Tresorbau GmbH & Co. KG
Industriestraße 10-24
D-37235 Hessisch Lichtenau
Tel. +495602 / 939 888
www.format-tresorbau.de
OPERATING AND MOUNTING INSTRUCTIONS
FORMAT Fire Safe Light