Wall/Ceiling Mounting FAP-U43xF16
Wall/Ceiling Mounting FAP-U43xF
Follow this procedure to attach the unit to a wall or ceiling using the supplied mounting
bracket.
1. Slide and attach the ceiling mount bracket to the bottom cover of the FortiAP unit.
If extra space is required to accommodate drop ceiling tiles, use the taller ceiling mount
bracket.
2. Select an appropriate location, hold the device against the ceiling t-rail, and push the For-
tiAP unit onto the ceiling until it snaps into place.
The unit can be removed from the bracket by pressing on the bracket tab and sliding the
device out.
Figure 1: Bracket attached
Figure 2: T-rail installed
Notes:
• One standard ceiling mount bracket is included in sizes: 1.43cm (9/16in) and 2.38cm (15/
16in).
To Next Page
Loading...
