Planning AP Location18
This command enables the sitesurvey mode. The AP will reboot into sitesurvey mode and dis-
play the sitesurvey prompt.
ss > _
Disabling Sitesurvey
sitesurvey disable
This command disables the sitesurvey mode. AP will reboot into normal mode of operation.
Setting Country Code and Channel
sitesurvey countrycode set <country code>
By default the country code is set to US. When you set a country code, the first valid channel
and the max supported Tx power for radio 0 and radio 1 for that country code is automatically
set. To override the default channel for a country code, enter the
sitesurvey channel set <radio_index> <channel> command.
Where,
• radio_index refers to the AP radios.
• Enter 1 for radio 0 (2.4 Ghz).
• Enter 2 for radio 1 (5Ghz).
To get the list of supported country codes, use the ss countrycode help command.
Note: Run the show config command in the sitesurvey mode to view the current configuration.
Setting Inactivity Time
sitesurvey inactivitytime <itime>
This command sets the time (in seconds) the AP will remain in the sitesurvey mode before a
client associates with it. The time is specified in seconds and by default the AP will remain in
the sitesurvey mode for 3600s. After the period of inactivity, the AP will reboot into normal AP
mode.
Setting IP Address
sitesurvey ipconfig <ip_address> <netmask>
This command configures the sitesurvey AP with an IP address. You can use this IP address
to access the sitesurvey GUI page via a browser. By default, the IP address and netmask are
set to 192.168.0.1 and 255.255.255.0.
To Next Page
Loading...
