Planning AP Location20
• radio_index can be 0, 1, or 3
• Enter 1 for radio 1 (2.4 Ghz)
• Enter 2 for radio 2 (5 Ghz)
• Enter 3 for both the radios
This command enables or disables AP radio. Wi-fi clients connecting to the sitesurvey AP
must use the same radio that is enabled in the AP. By default, both the radios are enabled.
Configure Sitesurvey Refresh Rate
sitesurvey statsrefrate [<rate>]
This command configures the time interval (specified in milliseconds) at which the AP will col-
lect and send (display) sitesurvey results. By default, the refresh rate is set to 1000ms. The
sitesurvey results can be viewed from the sitesurvey GUI page or the CLI.
Setting the Tx Power
sitesurvey txpwr set <radio_index> [<tx_power>]
Where,
• radio_index can be 0, 1, or 3
• Enter 1 for radio 1 (2.4 Ghz)
• Enter 2 for radio 2 (5 Ghz)
• Enter 3 for both the radios
Use this command to selectively set the transmit power for AP radios. By default, Tx power is
set to maximum possible Tx power based on the country code, channel and the hardware
capabilities. The sitesurvey txpwr set 3 command (without the power value) will set the
max Tx power supported for the selected country to both the radios.
Save Sitesurvey Configuration
sitesurvey save
After you have configured all sitesurvey options, enter this command to save your sitesurvey
configuration. This command creates an ESSID with all configured parameters. Your Wi-Fi
can now associate to this AP using the ESSID.
To Next Page
Loading...
