Fortinet FEX-511F - 3 IP Configuration; DHCP IP Address Assignment; Manual Static IP Setup; Web GUI Access Details

15
IP Conguration
3
After you have connected the FortiExtender network interfaces, the device automatically
attempts to obtain an IP address from a DHCP server. If you do not use DHCP, you can
congure a static IP address.
To congure a static IP address:
1. Use an Ethernet cable to connect one of the LAN ports to the Ethernet port of your
computer.
2. Set the computer Ethernet port to DHCP mode, and connect it to port1, port2, or port3.
3. Open your web browser and point to the default FortiExtender web GUI address:
http://192.168.200.99
4. In both the username and password elds, type admin and press the Enter key on
your keyboard. (Note: If you are logging in to the device for the rst time, you will be
prompted to change the default password. We strongly recommend that you change the
password right away.)
5. Go to Networking>Interface, where you’ll see all the system interfaces.
6. Select a desired interface, set it to “static” mode, congure the static IP address, and click
Save.
FortiExtender-511F-QuickStart.indd 15FortiExtender-511F-QuickStart.indd 15 7/22/2021 6:21:40 PM7/22/2021 6:21:40 PM