Fortinet FortiAP U431F - Supported Controller Types

To bring the FortiAP back to factory default setting, insert a pin into the reset point on the FortiAP unit
and hold on for 10 seconds. Release the pin.
On the FortiAP image, run the reload default factory command to reset the FortiAP to factory default.
14
Supported
Controller Types
FAP-U433F and FAP-U431F are compatible with FortiWLC
enterprise wireless LAN controllers, integrated FortiGate
enterprise rewall LAN controllers, and FortiAPCloud
management platform.
• If FortiWLC controller is discovered, the unit continues booting up with the default FortiWLC
image.
• If the FortiGate controller or the FortiAPCloud management platform is discovered, the unit
reboots with the FortiAP image.
For the FortiAP to discover the FortiAPCloud management platform, you need to add the unique
FortiAPCloud key labelled on the device to the FortiAPCloud. See section FortiAPCloud Deployment .
For the FortiAP to complete the FortiGate discovery, you need to authorize the FortiAP on the
FortiGate. See section FortiGate Deployment .