Personalizing your Phone Page 13 FortiFone™ User Guide for FON-260i
Display Name
When assigned, the Display Name is used in SIP calls as the Caller ID name.
To enter the Display Name:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 3. Display Name then press the OK button.
• Input the Display Name using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
User Name
A User Name (extension or phone number) is required for proper operation and must match the
user ID or account assigned in the SIP server. This is usually the number dialed to reach this line
on the phone.
To enter the User Name:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 4. User Name then press the OK button.
• Input the Name using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
Changing the User Name requires a reboot of the phone. When you exit the menu, you will
receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize the
new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
To Next Page
Loading...
