224 01-28006-0007-20041105 Fortinet Inc.
IP pool Firewall
IP pool options
Figure 103:IP pool options
Virtual IP has the following options.
Configuring IP pools
To add an IP pool
1 Go to Firewall > IP Pool.
2 Select the interface to which to add the IP pool.
You can select a firewall interface or a VLAN subinterface.
3 Select Create New.
4 Enter the IP Range for the IP pool.
The IP range defines the start and end of an address range. The start of the range
must be lower than the end of the range. The start and end of the range must be on
the same subnet as the IP address of the interface to which you are adding the IP
pool.
5 Select OK.
To delete an IP pool
1 Go to Firewall > IP Pool.
2 Select the Delete icon beside the IP pool you want to delete.
3 Select OK.
To edit a IP pool
1 Go to Firewall > IP Pool.
2 For the IP pool that you want to edit, select Edit beside it.
3 Modify the IP pool as required.
4 Select OK to save the changes.
Interface Select the interface to which to add an IP pool.
Name Enter a name for the IP pool.
IP Range/Subnet Enter the IP address range for the IP pool.
To Next Page
Loading...
