EasyManua.ls Logo

Fortinet FortiGate FortiGate-60 - Configuring the ADSL Interface Using the CLI; Syntax

Fortinet FortiGate FortiGate-60
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FortiGate-60ADSL FortiOS 3.0 MR6 Install Guide
40 01-30006-0448-20080131
Configuring the ADSL interface using the CLI Configuring the ADSL interface
Configuring the ADSL interface using the CLI
Configure the ADSL interface like any other FortiGate physical network interface.
The information that you need depends on the addressing mode your ISP requires
you to use.
This section shows settings that are unique to the ADSL interface and are not
described in other FortiGate documentation. Many settings that apply to interfaces
generally also apply to the ADSL interface. This section shows only the settings
that you might need to configure to communicate with your ISP. For a complete list
of interface settings, refer to system interface in the FortiGate CLI
Reference.
Syntax
config system interface
edit adsl
set auth-type <ppp_auth_method>
set defaultgw {enable | disable}
set disc-retry-timeout <pppoe_retry_seconds>
set distance <admin_distance>
set dns-server-override {enable | disable}
set gateway_address <IPv4>
set gwdetect {enable | disable}
set idle-timeout <pppoe_timeout_seconds>
set ip <interface_ipv4mask>
set ipunnumbered <unnumbered_ipv4>
set lcp-echo-interval <lcp_interval_seconds>
set lcp-max-echo-fails <missed_echoes>
set mode <interface_mode>
set mtu <mtu_bytes>
set mtu-override {enable | disable}
set mux-type { llc-encaps | vc-encaps}
set padt-retry-timeout <padt_retry_seconds>
set password <pppoe_password>
set pppoe-unnumbered-negotiate {disable | enable}
set status {down | up}
set username <pppoe_username>
set vci <integer>
set vpi <integer>
end
Virtual Circuit
Identification
Configure a virtual connection for the adsl modem. ATM uses these
values to identify the virtual channel of the next network that to transit
its packets. Enter values, supplied by your ISP, for the following:
VPI - Virtual Path Identifier
VCI - Virtual Channel Identifier
MUX Type Select the multiplexor type, supplied by your ISP. Select from:
LLC Encap - Logical Link Control Encapsulation
VC Encap - Virtual Circuit Encapsulation

Table of Contents

Other manuals for Fortinet FortiGate FortiGate-60

Related product manuals