Fortinet FortiSIEM 500F - Factory Reset; Step 1: Uninstall FortiSIEM application; Step 2: Reinstall FortiSIEM application; Upgrading FortiSIEM Collector

Appliance Setup
Factory Reset
Follow the steps below to perform factory reset on FortiSIEM FSM-500F.
Step 1: Uninstall FortiSIEM application
1.
Connect FortiSIEM device using VGA or Console port.
2.
Login as ‘root’ user with password 'ProspectHills'.
3.
To check the available FortiSIEM commands, run get.
4.
To uninstall FortiSIEM, run execute fsm-clean.
This script will uninstall FortiSIEM Collector.
Step 2: Reinstall FortiSIEM application
1.
Power on the hardware.
2.
Login as ‘root’ user with password 'ProspectHills'.
3.
To check Hardware status and RAID information, run diagnose hardware info.
Note: RAID Information is NOT applicable to FSM-500F model.
4.
To install FortiSIEM Collector, run ‘execute factoryreset’.
Note: This script takes 5 minutes to complete FortiSIEM Collector installation.
Follow the steps under Appliance Setup to configure FSM-500F.
Upgrading FortiSIEM Collector
For upgrading FortiSIEM Collector, refer to the Upgrade Guide.
Appliance Re-image
Ensure that the following prerequisites are met before re-imaging FortiSIEM.
Hardware Software
Peripherals
l USB Keyboard
l USB Mouse
l VGA Monitor
USB Thumbdrive
l 4 GB Thumbdrive (for Linux installation)
l 8 GB Thumbdrive (for FortiSIEM appliance
l
Ubuntu Desktop Setup Files
l
Rufus (Bootable USB Utility)
l
FortiSIEM Appliance Image
FortiSIEM 6.1.2 500F Collector Configuration Guide 13
Fortinet Technologies Inc.