Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 178

- 178 -
Default Setting
Enabled
Command Mode
Global Config
This command enables the sending of new root traps and topology change notification traps.
Syntax
snmp-server enable traps stpmode
no snmp-server enable traps stpmode
no - This command disables the sending of new root traps and topology change notification traps.
Default Setting
Enabled
Command Mode
Global Config
7.3.6 SNMP Trap Commands
7.3.6.1 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP
Network Manager. These messages alert the manager to events occurring within the switch or on the
network. Six trap receivers are simultaneously supported.
Syntax
show snmptrap
Default Setting
None
Command Mode
Privileged Exec
Display Message