Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 180

- 180 -
Default Setting
Disabled
Command Mode
Interface Config
This command enables link status traps for all interfaces.
i
This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Default Setting
Disabled
Command Mode
Global Config
7.3.6.4 snmptrap <name> ipaddr <ipaddr> <snmpversion>
This command adds an SNMP trap name. The maximum length of the name is 16 case-sensitive
alphanumeric characters.
Syntax
snmptrap <name> ipaddr <ipaddr> <snmpversion>
no snmptrap <name> <ipaddr> <snmpversion>
<name> - SNMP trap name (Range: up to 16 case-sensitive alphanumeric characters).
<ipaddr> - an IP address of the trap receiver.
<snmpversion> - SNMP trap version.
no - This command deletes trap receivers for a community.
Default Setting
None