Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 253

- 253 -
Command Mode
Global Config
7.8.3.3 dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port
security. The <user> parameter must be a configured user and the <listname> parameter must be a
configured authentication login list.
Syntax
dot1x login <user> <listname>
<user> - is the login user name.
<listname> - an authentication login list.
Default Setting
None
Command Mode
Global Config
7.8.3.4 dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Syntax
dot1x system-auth-control
no dot1x system-auth-control
no - This command is used to disable the dot1x authentication support on the switch.
Default Setting
Disabled
Command Mode
Global Config