Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 256

- 256 -
Default Setting
2
Command Mode
Interface Config
7.8.3.8 dot1x max-user
This command configures the maximum users to a specified port, The system’s default maximum users
of an interface has no limitation. If ‘no dot1x max-users’ command is executed, the system will reset the
maximum users to infinity. If the maximum users is specified or modified, the system should use the new
one.
Syntax
dot1x max-user <count>
no dot1x max-user
<count> - maximum users (Range: 1 – 16).
no - This command sets the system will reset the maximum users to infinity
Default Setting
16
Command Mode
Interface Config
7.8.3.9 dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Syntax
dot1x re-authentication
no dot1x re-authentication
no - This command disables re-authentication of the supplicant for the specified port.
Default Setting
Disabled
Command Mode
Interface Config