- 440 -
Retransmit Interval: A number representing the OSPF Retransmit Interval for the specified
interface.
Hello Interval: A number representing the OSPF Hello Interval for the specified interface.
Dead Interval: A number representing the OSPF Dead Interval for the specified interface.
LSA Ack Interval: A number representing the OSPF LSA Acknowledgment Interval for the specified
interface.
Transit Delay Interval: A number representing the OSPF Transit Delay for the specified interface.
Authentication Type: The OSPF Authentication Type for the specified interface are: none, simple,
and encrypt.
Metric Cost: The cost of the OSPF interface.
Passive Status: Shows whether the interface is passive or not.
OSPF MTU-ignore: Indicates whether to ignore MTU mismatches in database descriptor packets
sent from neighboring routers.
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type: Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. The OSPF Interface Type will be 'broadcast'.
State: The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router,
and backup designated router.
Designated Router: The router ID representing the designated router.
Backup Designated Router: The router ID representing the backup designated router.
Number of Link Events: The number of link events.
Local Link LSAs: The number of Link Local Opaque LSAs in the link-state database.
Local Link LSA Checksum: The sum of LS Checksums of Link Local Opaque LSAs in the link-state
database.
8.3.1.8 show ip ospf interface brief
This command displays brief information for the IFO object or virtual interface tables.
To Next Page
Loading...
