- 509 -
MLD Version: Indicates the version of MLD configured on the interface.
Query Interval: Indicates the configured query interval for the interface.
Query Max Response Time: Indicates the configured maximum query response time (in seconds)
advertised in MLD queries on this interface.
Robustness: Displays the configured value for the tuning for the expected packet loss on a subnet
attached to the interface.
Startup Query interval: This valued indicates the configured interval between General Queries sent
by a Querier on startup.
Startup Query Count: This value indicates the configured number of Queries sent out on startup,
separated by the Startup Query Interval.
Last Member Query Interval: This value indicates the configured Maximum Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages.
Last Member Query Count: This value indicates the configured number of Group-Specific Queries
sent before the router assumes that there are no local members.
The following information is displayed if the operational mode of the MLD interface is enabled.
Querier Status: This value indicates whether the interface is an MLD querier or non-querier on the
subnet it is associated with.
Querier Address: The IP address of the MLD querier on the subnet the interface is associated with.
Querier Up Time: Time elapsed in seconds since the querier state has been updated.
Querier Expiry Time: Time left in seconds before the Querier loses its title as querier.
Wrong Version Queries: Indicates the number of queries received whose MLD version does not
match the MLD version of the interface.
Number of Joins: The number of times a group membership has been added on this interface.
Number of Leaves: The number of times a group membership has been removed on this interface.
Number of Groups: The current number of membership entries for this interface.
9.3.1.3 show ipv6 mld traffic
Use this command to display MLD statistical information for the router.
To Next Page
Loading...
