Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 602

- 602 -
Default Setting
update - the default value is 30 (seconds)
garbage - the default value is 120 (seconds)
info - the default value is 180 (seconds)
Command Mode
Global Config
10.5.2.10 ipv6 rip passive-interface
The user can go to the CLI Interface Configuration Mode to set ipv6 rip passive, use the ipv6 rip
passive-interface interface configuration command. Use the no ipv6 rip passive-interface return to
the default value.
Syntax
ipv6 rip passive-interface
no ipv6 rip passive-interface
no - This command sets the RIPng timer to default value.
Default Setting
Disabled
Command Mode
Interface Config
10.6 Protocol Independent Multicast – Dense Mode (PIM-DM) Commands
10.6.1 Show Commands
10.6.1.1 show ipv6 pimdm
Use this command to display PIM-DM Global Configuration parameters and PIM-DM interface status.
Syntax
show ipv6 pimdm
Default Setting
None