Fortinet FortiVoice - Page 189

Fortinet Technologies Inc. Page 189 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
4. Click Create.
Action Depending on the selected Action type, click New to configure the
actions:
• If you select the Endpoint action type:
a. Select the FortiVoice operation schedule for the action.
Click Edit to modify the selected schedule or click New to
configure a new one. For more information on PBX
schedule, see “Scheduling the FortiVoice unit” on page 118.
b. Select an action for the incoming calls under this plan.
For some actions, you need to enter the extension (such as
Go voicemail) or select a profile (such as Play
announcement).
c. Click Create.
d. Repeat this procedure if you need more actions for this
action type.
Do not use the same schedule for more than one action to
avoid schedule conflict.
• If you select the Dial local number type:
a. Click New to add the number pattern in the Value field
following “Pattern-matching syntax” on page 196 and
“Pattern-matching examples” on page 196 for this dial plan.
Repeat to add more patterns.
b. For Strip, enter a number to omit dialing the starting part of
a pattern. 0 means no action.
For example, if your Match Pattern is 222XXXX and Strip is
3, the FortiVoice unit will only dial the last four digits for all
called numbers matching the pattern.
c. For Prefix, add a number before a pattern.
For example, if your Match Pattern is 9XXX and the numbers
under this pattern have been upgraded to have an
additional digit 5 at the beginning, you can enter 5 for the
Prefix. When an incoming call matches the pattern, the
FortiVoice unit will add a 5 before the number.
d. For Postfix, add a number after a pattern.
For example, if your Match Pattern is 9XXX and the numbers
under this pattern have been upgraded to have an
additional digit 5 at the end, you can enter 5 for the Postfix.
When an incoming call matches the pattern, the FortiVoice
unit will add a 5 after the number.
e. Click Create.
• If you select the Call routing type, select the available outbound
dial plans and click -> to move them into the Selected member
field. This means that the FortiVoice unit will route incoming
calls to an external phone system using the selected outbound
dial plans.