Fortinet FortiVoice - Configuring Logging to a Syslog Server or Fortianalyzer Unit

Fortinet Technologies Inc. Page 245 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
Table 33:Events logging options
Configuring logging to a Syslog server or FortiAnalyzer unit
Instead of or in addition to logging locally, you can store log messages remotely on a Syslog
server or a FortiAnalyzer unit.
You can add a maximum of three remote Syslog servers.
Before you can log to a remote location, you must first enable logging. For details, see
“Choosing which events to log” on page 244. For logging accuracy, you should also verify that
the FortiVoice unit’s system time is accurate. For details, see “Configuring the time and date” on
page 74.
To configure logging to a Syslog server or FortiAnalyzer unit
1. Go to Log & Report > Log Settings > Remote Log Settings.
Event Log Select this check box and then select specific events. No event types
are logged unless you enable this option.
• When configuration has changed: Log configuration changes.
• Admin login/logout event: Log all administrative events, such as
logins, resets, and configuration updates.
• System activity event: Log all system-related events, such as
rebooting the FortiVoice unit.
• SMTP server event: Log SMTP relay or proxy events. This option is
for local log setting only.
• HA: Log all high availability (HA) activity.
• DHCP event: Log DHCP server events. This option is for local log
setting only.
• Voice mail event: Log voicemail events. This option is for remote log
setting only.
• Monitor: Log call recording, call barging, and traffic capture events.
Voice Log Log phone call events. This option is for local log setting only.
Fax Log Log fax events.
DTMF Log DTMF (Dual Tone Multi-Frequency) events.
Hotel Log Log hotel management events, such as guest check-in and check-out.
Logs stored remotely cannot be viewed from the web-based manager of the FortiVoice unit. If
you require the ability to view logs from the web-based manager, also enable local storage.
For details, see “Configuring logging to the hard disk” on page 243.
GUI field Description
Enabled Select to enable remote storage on the server. Clear to disable
storage.