Fortinet FortiVoice - Page 258

Fortinet Technologies Inc. Page 258 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
6. As the FortiVoice units starts, a series of system startup messages are displayed.
Press any key to display configuration menu........
Immediately press a key to interrupt the system startup.
If you successfully interrupt the startup process, the following messages appears:
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[B]: Boot with backup firmware and set as default.
[I]: Configuration and information.
[Q]: Quit menu and continue to boot with default firmware.
[H]: Display this list of options.
Enter G,F,B,I,Q,or H:
7. Type G to get the firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.2.99]:
8. Type the IP address of the TFTP server and press Enter.
The following message appears:
Enter Local Address [192.168.2.99]:
9. Type a temporary IP address that can be used by the FortiVoice unit to connect to the TFTP
server.
The following message appears:
Enter File Name [image.out]:
10.Type the firmware image file name and press Enter.
The FortiVoice unit downloads the firmware image file from the TFTP server and displays a
message similar to the following:
Save as Default firmware/Backup firmware/Run image without
saving:[D/B/R]
Type R.
The FortiVoice image is loaded into memory and uses the current configuration, without
saving the new firmware image to disk.
11.To verify that the new firmware image has been loaded, log in to the CLI and type:
get system status
12.Test the new firmware image.
• If the new firmware image operates successfully, you can install it to disk, overwriting the
existing firmware, using the procedure “Installing firmware” on page 259.
• If the new firmware image does not operate successfully, reboot the FortiVoice unit to
discard the temporary firmware and resume operation using the existing firmware.
You have only 3 seconds to press a key. If you do not press a key soon enough, the FortiVoice
unit reboots and you must log in and repeat the execute reboot command.