Fortinet Technologies Inc. Page 67 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
6. For SIP UDP, configure the following:
7. For Interface monitor and Local hard drives, configure the following:
Example: Failover scenarios
This section describes basic FortiVoice active-passive HA failover scenarios. For each scenario,
refer to the HA group shown in Figure 23. To simplify the descriptions of these scenarios, the
following abbreviations are used:
• P1 is the configured primary unit.
• S2 is the configured secondary unit.
Timeout Enter the timeout period for one connection test.
Interval Enter the frequency of the tests.
Retries Enter the number of consecutively failed tests that are allowed before the
primary unit is deemed unresponsive and a failover occurs.
GUI item Description
Enable Select to enable SIP UDP service.
Name Displays the service name.
Remote IP Enter the peer IP address.
Port Enter the port number of the peer SIP UDP service.
Timeout Enter the timeout period for one connection test.
Interval Enter the frequency of the tests.
Retries Enter the number of consecutively failed tests that are allowed before the
primary unit is deemed unresponsive and a failover occurs.
GUI item Description
Enable Select to enable local hard drive monitoring. Interface monitoring is enabled
when you configure interface monitoring. See “Configuring interface
monitoring” on page 63.
Network interface monitoring tests all active network interfaces whose:
• “Virtual IP action” setting is not Ignore
• “Configuring interface monitoring” setting is enabled
For details, see “Configuring interface monitoring” on page 63 and “Virtual
IP action” on page 66.
Interval Enter the frequency of the test.
Retries Specify the number of consecutively failed tests that are allowed before the
local interface or hard drive is deemed unresponsive and a failover occurs.
GUI item Description
To Next Page
Loading...
