Swivel Base Operation
The vise is generally operated perpendicular to the workbench, enabling work to be
performed from either side of the vise. In some cases, the vise may need to be rotated to
allow better and safer access to the item.
In order to change the position of the vise, please follow the steps below:
Step 1: After the item is securely mounted in the vise, slowly loosen each lockdown
located on both sides of the vise. Care should be taken not to over-loosen or remove the
lockdowns as this may cause the vise to tip over and cause great bodily injury.
Loosen (turn counterclockwise) each lockdown about ¼ of a turn until the vise is able to
swivel from the base.
Step 2: Swivel the vise to allow better and safer access to the item.
Step 3: Tighten (turn clockwise) each lockdown so that the vise is securely clamped to
the base.
Full Version Of Terms And Conditions Of Sale
Available on-line at www.amazon.com/stores/node/8130830011 (select terms of sale).
Forward Tools
hongyuantools@outlook.com
To Next Page
Loading...