- 3 -
Ana-Digi QFL133
Normal Time Display
1. Press A to change mode. Mode sequence is normal time display, alarm, chronograph, and
time/calendar setting.
2. Press B for EL.
3. Press C to toggle 12/24-hour time.
NOTE: In any setting mode, if no pusher is operated for 2 minutes, all changes will be saved
and the setting will automatically return to normal time display.
Time and Calendar Setting
1. Press A to change to time/calendar setting mode; seconds will begin flashing.
2. Press C to set seconds to zero.
3. Press D to advance to next setting value.
4. Press C to increase digit, press and hold C for fast advance.
5. Setting sequence is: seconds, hour, minute, month, date and weekday.
6. Press A to exit setting mode.
Alarm Mode
1. Press A to change to alarm mode.
2. Press C to toggle alarm/chime on/off.
3. Alarm will sound at preset time for 20 seconds; press C or D to silence alarm.
Alarm Setting
1. In alarm mode, press D to enter setting mode; hour will begin flashing.
2. Press C to increase hour; press and hold C for fast advance.
3. Press D to set and advance to minutes.
4. Press C to increase minutes; press and hold C for fast advance.
5. Press D to save data and exit setting mode; press A to save data, exit setting mode, and return
to normal time display.
Chronograph Mode
1. Press A to change to chronograph mode.
2. Press C to start/stop the chronograph.
3. Press D to reset to zero.
Split Time
1. Press D while the chronograph is running for split time.
2. Press D again to return to chronograph.
3. Repeat steps 1 and 2 to measure multiple split times.
4. Press C to finalize timing.
5. Press D to reset to zero.
C
D
B
A
To Next Page
Loading...
Need help?
General