113
MR-8mkII Owner’s Manual (Part data editing)
5) Rotate the JOG dial to select "Change Part >" in
the second page, and press the [MENU/ENTER]
key.
The display now shows the screen for
selecting the source track(s) and destination
track(s) of the exchange operation.
Initially, "<< Back" is highlighted.
6) Rotate the JOG dial to select "Source Track=*",
and press the [MENU/ENTER] key.
You can now select the exchange source track(s)
by rotating the JOG dial.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
7) Rotate the JOG dial to select the source track(s)
to be exchanged, and press the [MENU/ENTER]
key.
You can now select the exchange destination
track(s) by rotating the JOG dial.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
1) Load the song you want to edit.
2) Set the LOCATE A and LOCATE B points (see
page 51).
You can check the parts by playing back
between the LOCATE A and LOCATE B points
(see page 46).
3) While the recorder is stopped, press the
[MENU/ENTER] key to enter the menu mode.
The display now shows the first page of the menu
selection screen, where "<< Back" is highlighted
initially (selecting "<< Back" returns to the
previous screen).
You can exchange the parts between the desired tracks. The part exchange operation can be
made only within the current song.
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
LOCATE A
point
LOCATE B
point
ABS ZERO
REC END
<Note>:
You cannot exchange data of a song pro-
tected. Release the protection before exchanging
parts.
4) Rotate the JOG dial to select "Part Edit >", and
press the [MENU/ENTER] key.
The display now shows the part edit menu
screen, where "<< Back" is highlighted.
<Note>:
You cannot select the same track(s)
for the exchange source and destination.
Exchange the part(s)
flashing
To Next Page
Loading...
Need help?
General
