Fox Easy Dome XS - Page 3

GB
5
GB
4
EASY DOME XS
EASY DOME XS
Assembly Instructions
Remove the Easy Dome XS from
its carryall and position so that
the central boss is visible lying
down between the ribs.
1.
Allow the ribs to drop outwards,
causing the central boss to rise up
towards you. Ensure that no material
has been trapped under the joints on
the central boss.
2.
Lift the dome into position
and snap each joint together.
3.
To close each joint simply push inwards until it
locks shut.
IMPORTANT: the joints will snap together with
minimal pressure. If undue resistance is felt then
STOP and check none of the ribs are twisted.
Work your way around the dome until all four
main ribs are assembled.
4.
Assemble the porch rib by lifting and snapping the
joint together. Close the middle joint first, followed
by the two outer joints. Attach the elastic loop over
the central rib and insert onto spigot as shown.
5.