Step 1: Prepare pads.
Connect 2 pads to the cord by snapping them on. Using the 1/4
wire, make sure that you use 1pc positive + 1pc negative wire
(different colors indicate is it the positive one or the negative one).
Remove the protective film.
(TENS pads)
(Pads attached to the forearm)
Step 2: Placing pads.
Place pads where the massager impact is desired, over or near
the injured area of the body. Make sure your skin is free from
any dirt, oil or lotion.
15
service@foxpeed.com
To Next Page
Loading...