SAFETY WARNINGS
The product must be installed only by qualified persons, according to the local safety standards and
regulations.
It is classified as Class II, in accordance with EN 60950-1.
Installation warnings
- Use only the original power cable, installing the product so that the mains plug is easily accessible.
- The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a
dry place.
- Leave enough space around the product housing to ensure sufficient ventilation. An excessive
operating temperature and/or an excessive heating may affect the performance and the life of the
product.
- Don’t install the product above or close to heat sources, in dusty places or where it might come into
contact with corrosive substances.
- Humidity and condensation could damage the product. In case of condensation, wait until the
product is dry before using it.
Important: Only instructed and authorized persons can open the product. In case of failure, do not try to
repair the product; otherwise the guarantee will no longer be valid.
Safety measurements
To Next Page
Loading...
General