1T 310'783 Operating Manual Ecolino / Ecopower Milk System Erstellt: 07.05.2002 Rev.: C SL: 20'987 BJC
page 42
6.1.6.2 Load Chip Cards
1. Insert the Load Card into the card reader
2. Press the "+" or "-" key until the parameter is obtained load chip cards
perform "shift"
3. Press the Shift key remove card
The Load Card must be removed
insert card
cash/load à
4. Insert the Cash Card into the card reader credit XX.XX
load sum 00.00
5. Using the "+" key, adjust the loaded amount by the credit XX.XX
loading factor programmed by the service engineer load sum 10.00
6. Press the Shift key to load this amount onto the credit XX.XX
Cash Card ...save...
credit 10.00
...done...
credit 10.00
load sum 00.00
7. Remove the Cash Card remove card
8. If further Cash Cards are to be loaded, steps 4 to 7 insert card
must be repeated. cash/load à
9. Insert the Load Card into the card reader load chip cards
perform "shift"
6.1.6.3 Clear Chip Cards
The credit on the Cash Card is cleared.
1. Insert the Load Card into the card reader
2. Press the "+" or "-" key until the parameter is obtained delete chip cards
perform "shift"
3. Press the Shift key remove card
The Load Card must be removed
insert card
cash/load à
To Next Page
Loading...
