Frauscher Sensortechnik GmbH WSC001 User Manual

D4586-0.2
Technical documentation
Wheel sensor Signal Converter
WSC001
Pos: 2 /MODULE/0 0_I ntro/Allgemeines/01_Fu ßzeile_0 2 @ 4\mod_1 42441 6514795_2901 .docx @ 5228 4 @ @ 1
Frauscher Sensortechnik GmbH
Gewerbestraße 1 | 4774 St. Marienkirchen | Austria
Tel. +43 (0) 7711 2920-0 | Fax +43 (0) 7711 2920-25
office@frauscher.com | www.frauscher.com
Name
Signature
Date
Technical documentation
Wheel sensor Signal Converter
WSC001
Classified
Prepared:
Susanna Schachinger
2016-07-12
Checked:
D4586-0.2
Released:
EN
1 / 62
© Frauscher Sensortechnik GmbH – All rights reserved. The reprinting, reproduction, storage on or in any data media or in any retrieval system, even if only in the form of extracts,
or the transfer to third parties, is only permitted with the express written consent of Frauscher Sensortechnik GmbH.
Pos: 3 /MODULE/0 0_I ntro/Allgemeines/02_I mpressum_ Meinung_ohne "DE Origin al"_01 @ 3\mod_ 14178 69786886_2901.docx @ 43 309 @ @ 1

Frauscher Sensortechnik GmbH WSC001 Specifications

General

Brand	Frauscher Sensortechnik GmbH
Model	WSC001
Category	Media Converter
Language	English

Summary

Safety

General protective provisions

Outlines crucial safety regulations and general protective measures for system operation.

Qualified personnel

Specifies the necessary qualifications and training for personnel handling the equipment.

Safety-conscious working

Emphasizes safe work practices and the operator's responsibility for occupational safety.

Intended use

Details the specific operational purpose and limitations of the product.

Basic conditions for the installation

Environmental conditions

Electromagnetic compatibility

Configuration

Setting of DIP-switches

Explains how to set the DIP-switches for configuring the WSC.

DIP-switches of the WSC

Details the function of each DIP-switch for WSC configuration.

Configuration of system outputs and/or direction outputs

Describes how to configure the system and direction outputs via DIP-switches.

Configuration of the normal status of all optocoupler outputs

Configuration of the output extension time

Configuration of the direction pulse length

Installation

Handling of boards

Wiring of the WSC

Details the process and pin assignments for wiring the Wheel Sensor Signal Converter.

Mounting and dismounting of the WSC

Explains the steps for mounting and removing the WSC from a top-hat rail.

Commissioning

Adjustment

Describes the procedure for adjusting the connected wheel sensor(s).

Maintenance

Check operations during the maintenance

Visual inspection and mechanical check of the wheel sensor

Check of the sensor current of the wheel sensor

Check of the occupancy detection capability

Repair

Diagnostics

Provides guidance on troubleshooting the Wheel Sensor Signal Converter.

Troubleshooting on the WSC

Details methods for troubleshooting issues with the WSC.

Measurements on the WSC with connected wheel sensor

LED indications on the WSC