FRC InView 360 HD AVM - Connecting System Components Together; Connecting to Vehicle Power Source

p. 10
AVM Around Vehicle Monitoring System Installation Guide
inView 360 HD Installation Guide
© Safe Fleet | July 2020 | All rights reserved
Document Number: XE-SNB100-C00-INSTALLPM-R0A
Putting the Components Together
Connecting to the Power Source
When connecting to the power sources, please ensure the following:
• Red goes to vehicle power
• Yellow goes to vehicle ignition
• Black goes to vehicle ground
You will have to splice fuses onto the red (vehicle power) and yellow (vehicle ignition) lines� Please ensure that the fuses
are as close to the power source as possible and that you use weather-proof fuse receptacles�
Also, it is important that the “extension” power lines are cut to length.
To battery To ignition To ground