FRC PumpBoss PBA100 - RPM Mode Operation

PBA100 Rev0305PreLim
18
PRELIMINARY DOCUMENT
FOR REFERENCE/REVIEW ONLY
PROGRAMMING
To gain access to the program features a four digit program code must be entered.
Review the Program Code Descriptions for the proper four digit code.
Both the MENU and SILENCE buttons are used to enter a program code. The
RPM display is used to show the codes.
Enter Program Code
Note: There is a time out feature that will return the program to normal
operation in three seconds if input is not detected at the buttons.
1. Press the SILENCE button and hold it for 3 seconds until the RPM display
shows four dashes. The program is ready for a three digit program code to be
input.
2. Press the MENU button. The RPM display will show the number 1000. Each
time the MENU button is pressed the first digit will scroll up by 1. Set the first
digit to the number desired.
3. Press the SILENCE button. Each time the SILENCE button is pressed the
second digit will scroll up by 1. Set the second digit to the number desired.
4. Press the MENU button. Each time the MENU button is pressed the third digit
will scroll up by 1. Set the third digit to the number desired.
5. Press the SILENCE button. Each time the SILENCE button is pressed the
fourth digit will scroll up by 1. Set the fourth digit to the number desired.
6. Wait a few seconds:
If a valid four digit program code is entered the display will change to show a
program value or an option.
If an invalid code is entered the display will show WRONG CODE.