PBA100 Rev0407
6
GENERAL DESCRIPTION
The PumpBoss pressure governors are compatible with the following engines:
PBA101 Cummins IS Series
PBA102 Detroit Diesel
PBA104 Navistar
PBA105 Caterpillar
PBA106* Ford
PBA108 Scania
PBA109* GMC
PBA110 Mercedes
* Note: An adapter and cable assembly replaces the basic 8-pin cable when
connecting the PumpBoss to a Ford or GMAC engine.
Components
The information available on the J1939 databus varies depending on the particular
engine type. Not all wires are used for all engines. Refer to the engine specific wiring
diagram for interface connections. The sensors (if any) that need to be installed will
also vary depending on the engine.
The PumpBoss consist of the following components:
Contol Module
Pressure Sensor
Engine Coolant Temperature Sensor (As Necessary)
Engine Oil Pressure Sensor (As Necessary)
Audible Alarm Buzzer (Optional)
Transmission Temperature Sensor (Optional)
Cables
Contol Module
The control module is waterproof and takes up 4 5/8 by 6 3/4 inches of panel
space. All controls and indicators are located on the front of the control panel. (Refer
to Controls and Indicators.)
To Next Page
Loading...
