PBA100 Rev0407
7
Pressure Sensor
The pressure sensor is mounted on the pump discharge manifold. It provides an
input signal to the control module that is proportional to the discharge pressure.
Engine Coolant Temperature Sensor
The engine coolant temperature sensor is installed as necessary.
Engine Oil Pressure Sensor
The oil pressure sensor is installed as necessary.
Audible Alarm Buzzer (Optional)
The optional buzzer is installed as required. A ground is provided at the 12-pin
connector pin 6 to activate the buzzer (max current: 300mA).
Transmission Temperature Sensor (Optional)
The optional transmission fluid temperature sensor is installed as required.
Cables
There are two cables that connect to the control module. The 8-pin connector is
for the remote throttle interface, the 12-pin connector is for the monitoring and display
interface.
To Next Page
Loading...
