PBA100 Rev0407
8
Controls and Indicators
All controls and indicators are located on the front of the control module. (Refer
to Figure 1.) See Operation and Programming Sections for more information.
OIL PRESSURE LED Display
Shows engine oil pressure. The LEDs will be green when the pressure is within
normal limits and red when it is not.
CHECK ENGINE LED
Repeats the check engine warning from the cab.
TEMPERATURE LED Display
Shows engine coolant temperature. The LEDs will be green when the temperature
is within normal limits and red when it is not.
RPM Display
Shows the current engine RPM in bright red digits. It also shows error codes, stored
data, and program features.
STOP ENGINE LED
Repeats the stop engine warning from the cab.
BATTERY VOLTAGE LED Display
Shows battery voltage. The LEDs will be green when the voltage is within normal
limits and red when it is not.
SILENCE Button
Press to suppress audio alarms.
PRESET Button
Press to change/select a pre-programmed value for pressure or RPM setting.
THROTTLE READY LED
This LED will be on when the required interlock conditions are met to begin pump
operations.
Message Display
The message display shows the pressure or RPM setting during normal operations
and warning alarms as they occur. It shows the time and date when the throttle ready
LED is off. It also shows stored data and program features.
IDLE Button
When pressed immediately sets the engine RPM to idle.
To Next Page
Loading...
