Do you have a question about the Fresh DOLPHIN 189.75 and is the answer not in the manual?
Heaters feature enamel coating for corrosion protection and foam insulation for heat loss reduction.
Magnesium anode sacrifices itself to prevent container corrosion, requiring annual inspection.
Intended for domestic use, installation by certified technician with adherence to building codes.
Ensure wall strength for mounting (8mm min. screws/bolts) and consider increased weight when filled.
Connect cold water input (blue) and hot water outlet (red). Insulate hot water pipes to avoid heat loss.
Installation of a mandatory safety unit is required but not included; it must be ordered separately.
Ensure the heater is full of water before operation to prevent damage to the heating element.
For extended absence, disconnect power, close input, open hot water, and connect drain to safety unit.
Connect to 230V-50Hz supply via a two-pole breaker, connecting to thermostat terminals and earth.
Verify the overheating fuse functionality before mounting the protective shield.
Ensure correct electrical installation and water filling. The indicator lamp shows heating phase.
Adjust temperature using the knob. Avoid setting below 60°C to prevent harmful bacteria.
Reset overheating protection manually via a small hole at the back of the thermostat module.
Periodically test the safety valve by activating its handle to ensure proper function.
Use suitable tools, replace seals, and clean with neutral soap. All maintenance by certified technicians.
Inspect the magnesium anode annually for corrosion or calcification. Replacement by certified technicians required.
Decalcify the heating element annually by switching off power, emptying, and cleaning components.
Dispose of electrical spare parts according to WEEE directive, not as normal refuse, but via recycling.
Covers issues like non-lighting indicators, noise, safety valve dripping, and their respective causes and solutions.
Information on obtaining spare parts lists via website or email contact.
Manufacturer disclaims responsibility for damages from improper installation, use, or maintenance.
Covers normal rights and an extended 5-year warranty against corrosion, requiring anode inspection.
Provides detailed specifications for 30L Dolphin and 50L/100L Marina models.
| Category | Water Heater |
|---|---|
| Power Source | Electric |
| Thermostat | Adjustable |
| Model | DOLPHIN 189.75 |
| Voltage | 220V |
| Frequency | 50 Hz |
| Safety Features | Pressure Relief Valve |