What to do if Friax Air Conditioner installation works but doesn’t cool enough?
If your Friax Air Conditioner doesn't cool enough, note that it may require several days to reach the set temperature, depending on the number of bottles stored. The air conditioner is designed to work in an environment without ventilation. Therefore, check the insulation of door frames and ensure there are no natural air inlets.
What to do if Friax SPC EVX Air Conditioner evaporator is clogged with ice?
If the evaporator of your Friax Air Conditioner is clogged with ice, do not unplug or turn off the air conditioner. Initiate a forced defrost for 3 seconds. Check the charge at the liquid indicator in the outdoor condensing unit.
Why is my Friax SPC EVX not starting?
If your Friax Air Conditioner is not starting, check the power supply and connections of the power terminals.
What to do if some water pours of the Friax SPC EVX evaporator somewhere else that by the full excess?
If water pours from the evaporator of your Friax Air Conditioner somewhere other than the designated excess, ensure the evaporator is level.
Why the ventilation is working but not the compressor in my Friax Air Conditioner?
If the ventilation is working but not the compressor in your Friax Air Conditioner, check if heating mode is not engaged.
Why does the humidification work non-stop on my Friax SPC EVX?
The humidification might work non-stop on your Friax Air Conditioner because the characteristics of the room, such as insulation and wall composition, do not permit reaching a high percentage of humidity (above 70%).
Advises against turning off the air conditioner in winter due to crankcase heater function.
Details power requirements (2x 1.5V AAA) and maximum range (100m).
Explains all numbered indicators and symbols on the remote control display.
Step-by-step guide to pair the controller with the remote control.
Procedure to reset the system using the remote control from version 4.0.
Instructions on how to start the unit and shorten waiting periods.
Guide for adjusting temperature and humidity setpoints on the Vintage version.
Procedure to access and change the cellar fan speed settings via the menu.
Table showing nominal fan speeds for different evaporator models.
Guidance on optimizing fan speed based on cellar configuration and evaporation temperature.
How to display the cellar temperature or humidity on the remote control.
Instructions for putting the fan in silent mode and exiting it.
Managing keypad lock/unlock and lighting control on the remote.
Procedures for pausing the remote screen, exiting standby, and stopping the machine.
How to start a manual defrost mode.
How to switch between 12-hour and 24-hour time display formats.
Procedure to set the current time and minute on the device.
How to select the temperature unit (°C or °F).
Procedure for calibrating the temperature sensor, adjusting for differences.
Procedure for calibrating the humidity probe, adjusting for gaps in moisture readings.
Configuring fan speed at setpoint for permanent air circulation.
Describes characteristics of Alarm Type 1 (continues operation) and Type 2 (stops operation).
Detailed table listing alarm codes, error sources, descriptions, and types.
Solutions for when the unit does not start or ventilation is not working.
Addressing issues with insufficient cooling or continuous humidification.
Solutions for water leaks from the evaporator or evaporator being clogged with ice.
Instructions for resetting the remote control to factory configuration (versions 2.1, 3.2, 4.0).
Steps to restart the unit and confirm it returns to standby mode after a reset.
Recommended maintenance operations every 6 months for optimal performance.
Checking unit integrity and cleaning the condensing and evaporator units.
Guidelines for proper disposal of the unit and its components.
General| Brand | Friax |
|---|---|
| Model | SPC EVX Series |
| Category | Air Conditioner |
| Language | English |
To Next Page
