33
Changing the light bulb
This device is made up of light-emitting diodes (LEDs). This type of diode
cannot be changed by the consumer. The lifetime of these LEDs is
normally sufficient for no changes to be made. If however, and despite all
the care taken during the manufacture of your device, the LEDs were
defective, please contact your after-sales service for any intervention.
Door reversal instructions
You can change the door opening direction, to the left (standard installation) or to the right,
depending on your installation needs.
Attention! When you reverse the door opening direction, the appliance must not be connected to
the mains. Make sure the plug is unplugged.
Note: Before laying the refrigerator horizontally to access the base, place foam packing or similar
material underneath to prevent damage to the rear panel. Stand the device upright. Open the upper
door to remove all the shelves (to avoid damaging them), then close the door. To reverse the door
opening direction, we recommend following the steps below.
1. Remove the upper right hinge,hinge
cover and left hinge cover with a
screwdriver.
2. Disconnect the connection line
between the door display and the
cabinet, and pull out the terminal as
shown in the figure.
To Next Page
Loading...
Need help?
General
