- 3 -
INSTALLATION
IMPORTANT: Never use with an extension cord. Power cord length is 5 feet long (1524 mm).
POWER SUPPLY
This beverage center is equipped with a 115V/60Hz single phase motor.
Do not use a ground-fault circuit interrupter (GFCI) outlet to connect the unit. (Fig. A.)
The power plug is a standard grounded three-prong non-polarized flush mount,
which allows for easier connection to power outlets.
Power plug must be connected to the outlet directly, and never to an extension cord.
RE SET
TEST
IMPORTANT: Do not cut or remove the third ground prong from the power cord.
POWER CORD
Never shorten or lengthen the power cord. Do not fold or coil the power cord.
IMPORTANT - Never place the excess length of power cord into the compressor enclosure in the
back of the beverage center. This action creates a dangerous heat build-up which can
melt the cord, cause an electrical hazard and may potentially cause a fire.
Touching the power cord to the compressor at the back of the unit during operation can create an
electrical hazard and damage the compressor.
If the power cord is damaged, it must immediately be replaced by a trained service provider, as
special tools are required.
CLEAN BEFORE USE
To remove any manufacturing dust and residual odors, wipe the beverage center inside and
out with a damp cloth and a solution of baking soda and warm water (2 tbsp. baking soda to 1 qt.
water). Wipe away any residual baking soda with a clean moist cloth. Allow to dry before operating.
Periodically clean the beverage center with a sponge or cloth moistened with mild soapy water,
or baking soda and water.
PROTECT FROM MOISTURE
Do not spray the beverage center with water.
PROTECT FROM HEAT
Place the beverage center away from heat source or direct sun.
Do not operate your beverage center outdoors or in an environment with high
Do not cover the beverage center with tarps or other items while operating, as this may
cause overheating.
cabinet, compressor and /
Heavy moisture in the environment can cause degradation to the insulation, as well as rust to the
or high humidity, such as garages, attics or outdoor patios.
variances will create condensation on the glass door.The temperature
/temperatures and
or power supply.
To Next Page
Loading...
