8
Shipping Hardware
Foam shipping restraint (inside wash tub)
removed and stored
Shipping bolt (underneath appliance) removed
and stored
Leveling
Washer is level, side-to-side and front-to-back
Cabinet is setting solid on all corners
Water Supply
Use only new hoses and verify rubber sealing
washers are installed
HOT supply is connected to HOT inlet and
COLD supply is connected to COLD inlet
HOT and COLD water supply turned on
No leaks present at water supply connections
or appliance inlet connections -
recheck in 24 hours
Drain
Stand pipe or wall drain height minimum 33”
Drain hose secured in place with cable tie
(shipped in drum)
Electrical Power
House power turned on
Washer plugged in
Final Checks
Installation Instructions
and
Use and
Care Guide
read thoroughly
Water enters drum when cycle starts with lid
lowered.
Registration card sent in
Installation Checklist
Í
NOTE
Hoses are not included with washer purchase. See
“Accessories” section for various inlet hose kits to fi t
your specifi c installation.
SECTION 2 - INSTALLATION INFORMATION
Pre-Installation Requirements
Tools and materials needed for installation:
• Adjustable wrench
• 3/8” (10 mm) box wrench
• Ratchet and socket set
• Adjustable pliears
• Carpenter’s level
• Inlet hoses(x2)
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one
person move or lift the appliance.
2 - 2
To Next Page
Loading...
Need help?
General
