To Next PageTo Next Page
Need help?Do you have a question about the Frigidaire FEX831FS0 and is the answer not in the manual?
General| Brand | Frigidaire |
|---|---|
| Model | FEX831FS0 |
| Category | Washer/Dryer |
| Language | English |
Details electrical service, branch circuit, and voltage requirements.
Specifies hot/cold water faucet type, location, and water pressure.
Outlines drain pipe diameter, standpipe height, and flow rate.
Covers duct type, vent hood, and crucial safety warnings for exhaust.
Specifies the required circuit amperage, power supply voltage, and frequency.
Describes the equipped 120-volt 3-wire power cord and its connection.
Conformity to local codes, ANSI Z223.1, and 1/2 inch gas pipe.
Requirement for an individual shutoff valve and test gage connection.
Instructions for disconnecting from gas supply during pressure testing.
Lists areas where installation is not permitted due to hazards.
Requirements for recess/closet installation, including ventilation.
Outside venting with metal duct and make-up air provision.
Adherence to Manufactured Home Construction & Safety Standard.
Diagram showing locations for vent, gas, electrical, and water connections.
Instructions for removing carton posts, foam, and securing clips.
Instructions for removing the mechanism shipping bolt and spacer block.
Specific requirements for proper and safe electrical installation.
Prohibits use of extension cords due to potential hazards.
Mandates U.L. approved strain relief for power cord.
Warns against mixing aluminum and copper wiring.
Emphasizes proper grounding for safety and avoiding shock.
Highlights risk of shock due to improper grounding conductor connection.
Recommends plugging into a properly grounded three-prong receptacle.
Details connecting power cord conductors to the terminal block.
Explains connecting ground, neutral, and power wires to the terminal block.
Flushing water lines and connecting inlet hoses to the water valve.
Instructions for leveling the unit on all four legs for stability.
Connecting the gas supply line with appropriate fittings and thread sealer.
Forming a "U" shape for the drain hose and securing it.
Connecting the exhaust duct to the outside duct work.
Plugging the power cord into a grounded outlet after checking power.
Running the washer and dryer through a cycle to check for proper operation.
Ensuring the dryer area is clear of combustible materials and vapors.
Note regarding bleeding air from the gas line for burner ignition.
Recommends reviewing the 'Avoid Service Checklist' before calling for service.
Warning to destroy packaging materials to prevent child suffocation risk.
Caution to label wires before disconnection to prevent wiring errors.
Emphasizes applying good safe practice and caution during installation.
