4
ENGLISH
Reading Error Codes
NOTIFICATION TYPE
COMMUNICATION
REPETITION OF COMMUNICATION SEQUENCE
BEEPS 5 BEEPS, BRIEF PAUSE, 12 BEEPS
SEQUENCE COMMUNICATED ONCE. REMAINS SILENT UNTIL CYCLE SE-
LECTOR IS ROTATED TO NEXT CODE. TO HEAR THE SEQUENCE AGAIN,
ROTATE THE CYCLE SELECTOR AWAY FROM AND THEN BACK TO THE
DESIRED POSITION.
Error Code Example: “E5C - Voltage too high on main board”
ERROR
NOTIFICATION
FIRST DIGIT OF ERROR CODE
BRIEF PAUSE BEFORE
SECOND DIGIT
SECOND DIGIT OF ERROR CODE
BEEPS
SHORT PAUSE
BETWEEN EACH BEEP
2 SECONDS
SHORT PAUSE
BETWEEN EACH BEEP
1 BEEP = 1
2 BEEPS = 2
3 BEEPS = 3
4 BEEPS = 4
5 BEEPS = 5
6 BEEPS = 6
7 BEEPS = 7
8 BEEPS = 8
9 BEEPS = 9
10 BEEPS = A
11 BEEPS = B
12 BEEPS = C
13 BEEPS = D
14 BEEPS = E
15 BEEPS = F
16 BEEPS = G
17 BEEPS = H
18 BEEPS = I
1 BEEP = 1
2 BEEPS = 2
3 BEEPS = 3
4 BEEPS = 4
5 BEEPS = 5
6 BEEPS = 6
7 BEEPS = 7
8 BEEPS = 8
9 BEEPS = 9
10 BEEPS = A
11 BEEPS = B
12 BEEPS = C
13 BEEPS = D
14 BEEPS = E
15 BEEPS = F
16 BEEPS = G
17 BEEPS = H
18 BEEPS = I
1. Error codes can only be read while in Diagnostic Mode.
2. Most recent error code will be communicated fi rst (position 1).
3. Rotate the cycle selector knob to position 1 through 5 to retrieve the fi ve most recent error codes.
4. Error codes will sound only once. To hear the code again, rotate cycle selector away from and then back to the
desired position.
5. No beeps and no LED fl ashes signifi es no error codes.
6. To clear all error codes, press and hold the START button for 6 seconds while in Alarm Mode.