CONCERN I POTENTIAL CAUSE I COHHON SOLUTION
DISPENSER (Ice & W_
Dispenser will not Dispenser lock out is engaged,
dispense ice,
There is no ice in the bin to
be dispensed_
The refrigerator doors are
not completely closed;
- Dispenser paddle haS
been pressed too long and
the dispenser motor has
overheated.
Ice dispenser is
jammed.
m
Dispenser will not
d spense water.
- Ice hasmelted and frozen
around auger due to infrequent
use, temperature fluctuations,
and/or power outages.
- Ice cubes are jammed
between ice maker and back
of ice container.
• Dispenser lock out is engaged_
water filter not seated
properly,
is not open.
- Water hasnot been dispensed
for an extended period of time.
- Unit not properly connected
to cold water line.
Water has an odd taste
and/or odor.
% Press and hold control lock for three seconds:
See the Ice maker iS not making anY ice section
above.
Be sure the refrigerator doors are completely closed,
• The motor overload protector Will reset in about
three minutes and then ice can be dispensed:
- Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper
position. When new ice is made, dispenser should
operate.
- Remove ice cubes that are jamming the dispenser.
Press and hold control lock for three seconds.
-RemoVe and rein_ll the Water filter. Be sure tO push the
filter firmly so that you hear it !_k solidly into pbsitionl
' Replace filter cartridge: Be sure tO remove protective
caps and push the filter firmly so that you hear it lock
solidly into position,
, open household Water line Valve: see CONCERN
column AUTOMATIC ICE MAKER:
- Draw and discard 10-12 glasses of water to freshen
the supply.
- Connect unit to cold water line that supplies water to
the kitchen faucet.
Water pressure is Cut-off and cut-on pressures _ Have someone turn up the cut, off and cut-on pressure
extremely tow, are too low (well systems only), on the water pump system (wel! systems onty),
Reverse osmosis System is is normal for a reverse osmosis sYstem tO be below
.........in reqenerative phase, .........20 psi during the regenerative#hase:
Water not cold enough. - As warmer tap water goes - Add ice to cup or container before dispensing water.
through the filter and enters
the water tank, chilled
water is pushed through to
the dispenser. Once chilled
water is used up, it will take
several hours to bring the
freshly replaced water to a
cooler temperature.
OPENING/CLOSING OF DOORS/DRAWERS
Door(s) will not close.
Drawers are difficult to
- Door was closed too hard,
causing other door to open
slightly.
- Refrigerator is not level.
It rocks on the floor when
moved slightly.
- Refrigerator is touching a
wall or cabinet.
- Close both doors gently.
- Ensure floor is level and solid, and can adequately
support the refrigerator. Contact a carpenter to
correct a sagging or sloping floor.
- Ensure floor is level and solid, and can adequately
support the refrigerator. Contact a carpenter to
correct a sagging or slop_
• R_etop ayer of items in drawer.
- Ensure drawer is properly installed on track!
Clean drawer, rollers, and track. See Care&Cleaning,
To Next Page
Loading...
