Removethetwobottomhingescrewsand 2
hingeifnecessary.
31
Screws -
Adjustable Hinge (some models)
To reinstall the refrigerator door, reverse the
above steps.
To remove the freezer top hinge cover:
i Remove the two screws from each cover
over the top door hinges.
2 Lift hinge cover straight up and off.
Front Rear
Cover Screws Cover
rew
Top
Multi-Wire
Cable
|
4
To remove the freezer door:
i Detach the multi-wire cable connector
located above the top hinge. Grasp both
sides of the connector firmly and pull apart.
Trace lightly around the hinge with a
pencil. This makes reinstallation easier.
Detach the water tube from the connector
located below the freezer door. The
connector releases when you press its
outer sleeve inward.
Remove the screws from the top hinge
and pull the multFwire cable through it.
Lift the door off of the bottom hinge.
Remove the two bottom hinge screws and
hinge if necessary.
To Disconnect
1. Press outer ring against face
of fitting_
_2. Pullto
remove tube
push until mark touches face of fitting
Adjustable Hinge (some models)
Door
>, > Water
Tub!ng
Hinge \
Assembly Screws
Non=Adjusting Hinge (some models)
6 Lay the door on its side to avoid damage
to the water tube extending from the
bottom hinge.
To reinstall the freezer door, reverse the above steps.
Be sure doors are set aside ina secure position
where they cannot fall and cause personal injury.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
